#CISCO MAC ADDRESS TABLE ж›ґж–° SOFTWARE#
#CISCO MAC ADDRESS TABLE ж›ґж–° LICENSE#

Since the output is too long, the rest of the output is omitted. VLAN MAC Address Type age Secure NTFY Ports/

* - primary entry, G - Gateway MAC, (R) - Routed MAC, O - Overlay MACДЄge - seconds since last seen,+ - primary entry using vPC Peer-Link, The output of the above command in the privilege command mode prompt inside the real Cisco Router Network Device : A copy of eachДЄfter successfully connected to Cisco Router Network Device, execute the following command to display MAC Address List :

#CISCO MAC ADDRESS TABLE ж›ґж–° LICENSE#

Lesser General Public License (LGPL) Version 2.1. The GNU General Public License (GPL) version 2.0 or the GNU

#CISCO MAC ADDRESS TABLE ж›ґж–° SOFTWARE#

Certain components of this software are licensed under Owned by other third parties and used and distributed under The copyrights to certain works contained in this software are To display the output which has several contents of MAC Address List, below is another example of the command execution done by performing remote access via SSH service to a real Cisco router network device ssh Access VerificationД¬isco xxxxx xxxxx xxxxxxxxxx (XXXX-XXXX) SoftwareД¬opyright (c) 2002-2012, Cisco Systems, Inc. The image below shows how the device is actually located which is a single device without any connection elsewhere : Since the above device is not even connected to any other devices, it doesnвЂ™t record any MAC Address of any devices at all, show the table of MAC Address List displayed is empty.

This is the sample of the executed output shown in the image : After enabling privilege command mode has already done successfully, type the вЂshow mac address-tableвЂ™ command in it as shown below : To enable a privilege command mode in a router, read the following article title вЂEnabling Cisco Network Device to Permit Privilege CommandвЂ™ in this link. So, in order to display that information about the MAC address entries which is displayed in the form of a table, use the show mac address-table command and type it in the command prompt provided in the CLI (Command Line Interface) within the privilege command mode.

Cisco mac address table ж›ґж–°